Ruijie RG-S2600G-I Series - Page 817

CLI Reference NFPP Configuration Commands
configuration and removing the monitored hosts.
When the maximum monitored host number has been
exceeded, it prompts the message that %
NFPP_ARP_GUARD-4-SESSION_LIMIT: Attempt to exceed limit
of 1000 monitored hosts.to remind the administrator.
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcp-guard monitored-host-limit 200
Related
commands
Command
Description
show nfpp dhcp-guard
summary
Show the configurations.
dhcp-guard rate-limit
Use this command to set the rate-limit threshold globally.
dhcp-guard rate-limit { per-src-mac | per-port} pps
Parameter
description
Parameter
Description
per-src-mac
Set the rate limit for each source MAC
address.
per-port
Set the rate limit for each port.
pps
Set the rate limit, in the range of
[1,9999]
Default
Settings
The default rate limit for each source MAC address is 5pps; the
default rate limit for each port is 150pps.
Command
mode
NFPP configuration mode.
Usage
guidelines
N/A
Examples
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcp-guard rate-limit per-src-mac 8
Ruijie(config-nfpp)# dhcp-guard rate-limit per-port 100