Ruijie RG-S2600G-I Series - Page 820

CLI Reference NFPP Configuration Commands
nfpp dhcp-guard isolate-period
Use this command to set the isolate period in the interface configuration mode.
nfpp dhcp-guard isolate-period {seconds | permanent}
Parameter
description
Parameter
Description
seconds
Set the isolate period, in second. The
valid range is 0, or [30, 86400]. 0
indicates no isolation.
permanent
Permanent isolation.
Default
Settings
By default, the isolate period is not configured.
Command
mode
Interface configuration mode.
Usage
guidelines
N/A
Examples
Ruijie(config)# interface G0/1
Ruijie(config-if)# nfpp dhcp-guard isolate-period 180
Related
commands
Command
Description
dhcp-guard
isolate-period
Set the global isolate period.
show nfpp
dhcp-guard
summary
Show the configurations.
nfpp dhcp-guard policy
Use this command to set the rate-limit threshold and the attack threshold.
nfpp dhcp-guard policy { per-src-mac | per-port} rate-limit-pps attack-threshold-pps
Parameter
description
Parameter
Description
per-src-mac
Set the rate-limit threshold and the
attack threshold for each source