Ruijie RG-S2600G-I Series - Page 821

CLI Reference NFPP Configuration Commands
MAC address.
per-port
Set the rate-limit threshold and the
attack threshold for each port.
rate-limit-pps
Set the rate-limit threshold with the
valid range of [1, 9999].
attack-threshold-pps
Set the attack threshold with the
valid range of [1, 9999].
Default
Settings
By default, the rate-limit threshold and the attack threshold are not
configured.
Command
mode
Interface configuration mode.
Usage
guidelines
The attack threshold value shall be equal to or greater
than the rate-limit threshold.
Examples
Ruijie(config)# interface G 0/1
Ruijie(config-if)# nfpp dhcp-guard policy per-src-mac 3 10
Ruijie(config-if)# nfpp dhcp-guard policy per-port 50 100
Related
commands
Command
Description
dhcp
-guar
d
attac
k-thr
esho
ld
Set the global attack threshold.
dhcp
-guar
d
rate-l
imit
Set the global rate-limit threshold.
show nfpp
dhcp-guard
summary
Show the configurations.
show nfpp
dhcp-guard hosts
Show the monitored host.
clear nfpp
dhcp-guard hosts
Clear the isolated host.