CLI Reference NFPP Configuration Commands
show nfpp
dhcpv6-guard summary
dhcpv6-guard rate-limit
Use this command to set the rate-limit threshold globally.
dhcpv6-guard rate-limit { per-src-mac | per-port} pps
Set the rate limit for each source MAC
address.
Set the rate limit for each port.
Set the rate limit, in the range of
[1,9999]
The default rate limit for each source MAC address is 5pps; the
default rate limit for each port is 150pps.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# dhcpv6-guard rate-limit per-src-mac 8
Ruijie(config-nfpp)# dhcpv6-guard rate-limit per-port 100
Set the rate limit and the
attack threshold.
show nfpp
dhcpv6-guard
summary
To Next Page
Loading...
