CLI Reference NFPP Configuration Commands
nfpp dhcpv6-guard enable
The DHCPv6 anti-attack function is not enabled on the interface.
Interface configuration mode.
The interface DHCPv6 anti- attack configuration is prior to
the global configuration.
Ruijie(config)# interface G0/1
Ruijie(config-if)# nfpp dhcpv6-guard enable
Enable the anti-ARP attack
function.
sho
w
nfpp
dhcp
v6-g
uard
sum
mary
nfpp dhcpv6-guard isolate-period
Use this command to set the isolate period in the interface configuration mode.
nfpp dhcpv6-guard isolate-period {seconds | permanent}
Set the isolate period, in second. The
valid range is 0, or [30, 86400]. 0
indicates no isolation.
To Next Page
Loading...
