CLI Reference NFPP Configuration Commands
Set the attack threshold for each port.
Set the attack threshold, in pps. The
valid range is [1,9999].
By default, the attack threshold and the rate-limit threshold for each
source IP address and each port are the same. For the default
rate-limit threshold value, see the icmp-guard rate-limit command.
Ruijie(config)# nfpp
Ruijie(config-nfpp)# icmp-guard attack-threshold per-src-ip 600
Ruijie(config-nfpp)# icmp-guard attack-threshold per-port 1200
Show the rate-limit threshold
and attack threshold.
show nfpp icmp-guard
summary
show nfpp icmp-guard
hosts
Show the monitored host
list.
clear nfpp icmp-guard
hosts
Clear the monitored host.
icmp-guard enable
Use this command to enable the ICMP anti-attack function.
icmp-guard enable
To Next Page
Loading...
