CLI Reference NFPP Configuration Commands
Interface configuration mode.
This command takes effect only after the name of the
user-defined anti-attack and the match, rate-count,
rate-limit and the attack-threshold have been configured.
Ruijie(config)# interface G0/1
Ruijie(config-if)# nfpp define tcp enable
Show the user-defined anti-attack
configurations
nfpp define name isolate-period
Use this command to set the local isolate period in the interface configuration mode.
nfpp define name isolate-period {seconds | permanent}
Set the isolate period, in second. The
valid range is 0, or [30, 86400]. 0
indicates no isolation.
Name of the user-defined anti-attack
type.
By default, the local isolate period is not configured. The global
isolate period is used.
Interface configuration mode.
To Next Page
Loading...
