Ruijie RG-S29 Series - Page 570

Command Reference DHCP Commands
4.38 lease-threshold
Use this command in DHCP address pool configuration mode to define the DHCP alarm threshold.
Use the default or no form of this command to restore the default setting.
lease-threshold percentage
defaut lease-threshold
no lease-threshold
Parameter
Description
Parameter
Description
percentage
Usage of the address pool, ranging from 60 to 100 in percentage.
Defaults
90
Command
Mode
DHCP address pool configuration mode.
Usage Guide
If the maximum IP usage of the address pool reaches the threshold, the DHCP Server generates a
SYSLOG alarm. The IP usage indicates the ratio of the number of assigned address pools to the total
number of assignable address pools. If the number of assigned pools stays above the alarm
threshold, an alarm is generated every 5 minutes.
Configuration
Examples
The following example sets the alarm threshold to 80%.
lease-threshold 80
The following example restores the default alarm threshold.
default lease-threshold
The following example disables the address pool alarm function.
no lease-threshold
Related
Commands
Command
Description
ip dhcp pool
Defines the name of the DHCP address pool and enters the DHCP
address pool configuration mode.
Platform
Description
N/A
4.39 netbios-name-server
Use this command to configure the WINS name server of the Microsoft DHCP client NETBIOS in the
DHCP address pool configuration mode. The no form of this command can be used to restore the
default setting.
netbios-name-server ip-address [ ip-address2…ip-address8 ]
netbios-name-server