Ruijie RG-S2900G-E Series - Configuring a Vlan; Default Vlan Configuration

Configuration Guide VLAN Configuration
Supported VLAN
Complying with IEEE802.1Q Standard, our products support up to 4094
VLANs(VLAN ID 1-4094 ), in which VLAN 1 is the default VLAN that cannot be
deleted.
VLAN Member Type
You can determine the frames that can pass a port and the number of VLANs
that the port can belong to by configuring the VLAN member type of the port.
For the detailed description about VLAN member type , see the following table:
Member Type
Port Feature
Access
One access port can belong to only one VLAN,
which must be specified manually.
Trunk (802.1Q)
By default, one Trunk port belongs to all the VLANs
of the device itself, and it can forward the frames of
all the VLANs. However, you can impose restriction
by setting a list of allowed VLANs.
Configuring a VLAN
A VLAN is identified by its VLAN ID. You can add, remove, and modify the
VLANs in the range of 2 to 4094 on a device. VLAN 1 is created by a device
automatically and cannot be removed.
You can configure the member type of a port in a VLAN, add a port to a VLAN,
and remove a port from a VLAN in the interface configuration mode.
Saving the VLAN Configuration
To save the VLAN configuration in the configuration file, execute the copy
running-config startup-config command in the privileged mode. To view
VLAN configuration, execute the show vlan command.
Default VLAN Configuration
The following table shows the default configuration of a VLAN.
Parameter
Default value
Range
VLAN ID
1
1 to 4094
VLAN Name
VLAN xxxx, where xxxx is the VLAN ID
None
VLAN State
Active
Two status:
active or inactive