Ruijie RG-S2900G-E Series - Page 203

Configuration Guide Protocol VLAN Configuration
The following example applies profile 1 and profile 2 to the GE interface 1 of
Slot 3. The VLAN categories are VLAN 101 and 102:
Ruijie# configure terminal
Ruijie(config)# interface gi 3/1
Ruijie(config-if)# protocol-vlan profile 1 vlan 101
Ruijie(config-if)# protocol-vlan profile 2 vlan 102
Ruijie(config-if)# end
Ruijie# show protocol-vlan profile
profile frame-type ether-type Interfaces|vid
------- --------- ---------- --------------
1 ETHERII EHTER_AARP gi3/1|101
2 SNAP ETHER_APPLETALK gi3/1|102
Note
1. All profiles can be applied to each interface.
2. Different VIDs can be specified for the same profile on
different interfaces.
3. The number of VIDs vary with different series of
products.
Showing a Protocol VLAN
To show a protocol VLAN, execute the following command:
Command
Description
show protocol-vlan
Show a protocol VLAN.
Ruijie# show protocol-vlan
ip mask vlan
------------- ------------- ----
192.168.100.3 255.255.255.0 100
profile frame-type ether-type Interfaces|vid
------- --------- ---------- --------------
1 ETHERII EHTER_AARP gi3/1|101
2 SNAP ETHER_APPLETALK gi3/1|1