Configuration Guide DHCPv6 Relay Agent Configuration
Network Topology
Figure-3 Network Topology for DHCPv6 Relay Agent
Configuration Tip
Enabling the DHCPv6 Relay Agent function for the PC gateway will direct the destination to the known server
address or the next-hop Relay address.
Configuration Steps
1) Enable the DHCPv6 Relay Agent function on the Device1 and specify the destination address 3001::2:
Ruijie#config
Enter configuration commands, one per line. End with CNTL/Z
Ruijie(config)#interface vlan 1
Ruijie(config-if)# ipv6 dhcp relay destination 3001::2
2) Enable the DHCPv6 Relay Agent function on the Device2 and specify the destination address
FF02::1:2:
Ruijie#config
Enter configuration commands, one per line. End with CNTL/Z
Ruijie(config)#interface vlan 1
Ruijie(config-if)#ipv6 dhcp relay destination FF02::1:2 interface gi 0/1
Showing Verification
1) Show the DHCPv6 Relay Agent configurations on the Device1:
Ruijie# show ipv6 dhcp relay destination all
Interface: Interface vlan 1
To Next Page
Loading...
