Configuration Guide RLDP Configuration
neighbor bridge : 0000.0000.0000
neighbor port :
bidirection detect information :
action : warnning
state : error
As shown above, port GigabitEthernet 0/1 is configured with unidirection detection. No error is
detected now, and the port status is normal. Port GigabitEthernet 0/24 is configured with
bidirection detection, and bidirection fault is detected.
Viewing the RLDP Status of the Specified Port
In the privileged mode, run the following command to view the RLDP detection information of
the specified port:
In the example below, the show rldp interface GigabitEthernet 0/1 command is used to view
the RLDP detection information of port fas0/1:
Ruijie# show rldp int GigabitEthernet 0/1
port state :error
local bridge : 00d0.f8a6.0134
neighbor bridge : 00d0.f822.57b0
neighbor port : GigabitEthernet 0/1
unidirection detect information:
action: shutdown svi
state : normal
bidirection detect information :
action : warnning
state : normal
loop detect information :
action: shutdown svi
state : error
As shown above, the port GigabitEthernet 0/1 is configured with three detection types:
unidirection detection, bidirection detection and loop detection. The troubleshooting methods
are shutdown-svi and warning. Error is found in loop detection so the current port status is error.
Accordingly, the SVI of the port is shutdown.
To Next Page
Loading...
