Configuration Guide TPP Configuration
As shown in the figure, A and B are L3 convergence devices, while C, D and E are L2
access devices.
The MSTP enabled on A, B, C, D, and E, and VRRP enabled on A and B. The topology
protection function enables the MSTP and VRRP to operate more reliable, avoiding
unnecessary vibration of the network topology.
The global topology protection function is enabled on A, B, C, D, and E, and the
topology protection function is enabled on all the ports..
View TPP information
Viewing the TPP configuration and status of the device
In the privileged mode, run the following command to view the TPP configuration and
status of the device:
To Next Page
Loading...
