Configuration Guide Syslog Configuration
Ruijie(config)# logging on
Ruijie(config)# no logging on
Do not turn off the log switch in general case. If it prints too much information,
you can reduce it by setting different displaying levels for device log
information.
Configuring the Device Displaying the Log Information
When the log switch is turned on, the log information will be displayed on the console
and also sent to different displaying devices. To configure different displaying devices
for receiving logs, run the following commands in the global configuration mode or
privileged level:
Ruijie(config)# logging buffered [buffer-size |
level]
Record log in memory buffer
Ruijie# termninal monitor
Allow log to be displayed on VTY window
Ruijie(config)# logging host
Send log information to the syslog sever in the
network
Ruijie(config)# logging file flash:filename
[max-file-size] [level]
Record log on extended FLASH
Logging Buffered will record log information in the memory buffer. The memory buffer
for log is used in recycled manner. That is, when it is full, the oldest information will be
overwritten. To show the log information in the memory buffer, run show logging at
the privileged user level. To clear the log information in the memory buffer, run clear
logging at the privileged user level.
Terminal Monitor allows log information to be displayed on the current VTY (such as
the telnet window).
Logging Host specifies the address of the syslog server that will receive the log
information. Our product allows the configuration of at most 5 syslog servers. The log
information will be sent to all the syslog servers at the same time.
To send the log information to the syslog server, it is required to turn on the
timestamp switch or sequential number switch of the log information.
Otherwise, log information will not be sent to the syslog server.
Logging File Flash: Record log information in FLASH. The filename for log shall not
have any extension to indicate the file type. The extension of the log file is fixed as txt.
Any configuration of extension for the filename will be refused.
To Next Page
Loading...
