Ruijie RG-S2900G-E Series - Showing the Span Status

Configuration Guide SPAN Configuration
Configuring the Flow-based Mirror
To configure the flow-based mirror, execute the following commands:
Command
Function
Ruijie(config)# [no] monitor session
session_number source interface
interface-id rx acl name
Specify the matched ACL name for
the mirrored flow and the mirrored
source and destination ports.
Only the incoming port mirror is supported.
For the ACL configuration commands, see the related configuration guide.
Showing the SPAN Status
The show monitor command shows the current SPAN status. The following
example illustrates how to show the current status of SPAN session 1.
Ruijie# show monitor session 1
sess-num: 1
src-intf:
GigabitEthernet 3/1 frame-type Both
dest-intf:
GigabitEthernet 3/8