Release Notes Upgrade Instructions (12.x)
16
Under the address configuration menu, enter the switch address, the execution PC
address, and the BIN file.
************************************************
Press a key to run the command:
enter the Local IP:[]:192.12.1.1
This address is the switch address,
configured in the same network segment as the execution PC.
enter the Remote IP:[]:192.12.1.2
This address is the PC address.
enter the Filename:[]:
S6150-X_RGOS12.6(2)B1302_09192208_install.bin
This file
name serves as an example.
The upgrade operation starts after the above address and file name were set.
% Total % Received % Xferd Average Speed Time Time Time Current
Dload Upload Total Spent Left Speed
147M 100 147M 0 0 1902k 0 0:01:19 0:01:19 --:--:-- 1968k
100 147M 100 147M 0 0 1902k 0 0:01:19 0:01:19 --:--:-- 1902k
Upgrading, keep power on and wait please ...
Select Y as prompted to continue the next step until it prompts “upgrade success”
(the upgrade file is copied successfully).
Determined to upgrade? [Y/N]: Y
Mount File System ...
Copy file to Flash ...
Upgrade Rootfs Success.
Upgrade Success
After the upgrade file is copied successfully, it automatically returns to the
Rboot menu interface. Press Ctrl+Z to exit the menu item for reboot. (You can
also directly power off and restart the device.)
====== Rboot Menu(Ctrl+Z to upper level) ======
Tftp utilities.
************************************************
0. Upgrade uboot program.
1. Upgrade rboot program.
2. Upgrade main program.
3. Burn the total FlashROM by this downloaded file.
************************************************
Press a key to run the command:
====== Rboot Menu(Ctrl+Z to upper level) ======
TOP menu items.
************************************************
0. Tftp utilities.
1. XModem utilities.
2. Run main.
Select
Run main
, and the switch will automatically restart.
3. SetMac utilities.
4. Scattered utilities.
To Next Page
Loading...
