1. permanent filter 9. slot
2. tab 10. overflow
3. handle 11. hotplate
4. filter holder 12. lid
5. non-drip valve 13. press
6. grip 14. handle
7. lid 15. carafe
8. water
OPERATING INSTRUCTIONS:
Before using the appliance for the first time:
Fill the reservoir to the mark, and run the appliance without coffee.
Allow for the coffee maker to cool down, discard the water, and then use it normally.
Filling the reservoir:
1. Remove the carafe from the hotplate.
2. Use the grip to open the lid, and expose the reservoir.
3. Use the carafe to fill the reservoir, to avoid overfilling.
a. Press the lever at the rear of the carafe lid, above the handle, to open the carafe lid.
4. Fill with at least 2 cups of water, but not above the mark.
5. Put filter-ground coffee into the filter. The amount will vary with the type of coffee
and individual taste, but we suggest two rounded teaspoons per cup of water.
6. Close the lid.
7. Replace the carafe on the hotplate.
Switching on the machine
8. Make sure the plug has been plugged into the power socket.
Operating the machine
To Next Page
Loading...
