8
Always remove the power cord from the socket and ensure that the appliance is OFF
before cleaning.
Only use the appliance in a room that is dry and clean.
FILLING THE WATER RESEVOIR
1. Remove the carafe from the hotplate.
2. Lift the lid off the reservoir.
3. Fill with at least 2 cups of water, but not above the max mark.
4. Replace the reservoir lid.
5. The arrow on the lid must point towards the appliance.
6. Alternatively, you may lift the reservoir off the appliance, fill it in the kitchen, and carry it
back to the appliance. If you do this, make sure that the reservoir is in place, and catches
the top of the reservoir and is hooked over the tabs in the body of the appliance, before you
proceed.
FILLING THE FILTER HOLDER
1. Press the lid lock to open the filter lid.
2. Put 6g (1 rounded teaspoon) of filter-ground coffee in the filter for each cup of water.
3. Close the lid, and press down to lock it.
4. Replace the carafe on the hotplate
SWITCHING ON
• Put the plug into the power socket. The appliance will beep.
• The power light will glow as long as the appliance is connected to the electricity
supply. Press and release the power button.
• Shortly afterwards, coffee will start to drip into the carafe.
• When it’s done, the hotplate will keep the carafe warm.
• The status light will change colour to show how fresh the coffee is.
blue (flashing) brewing
green 0-15 minutes since brewing
purple 15-30 minutes since brewing
red 30-40 minutes since brewing
• After 40 minutes, the hotplate will switch off.
To Next Page
Loading...
