Installation with brackets
• This type of installation may be required if the aperture dimensions are
insufficient with the wooden cabinet base fitted or there is no cabinet base.
• Remove the wooden cabinet base.
• Set the front edge of the brackets 50mm from the front edge of the aperture
opening/cabinet. The bottom face of the brackets (face A) 720mm from top of
the furniture as illustrated in the below picture.
• Fix the two brackets to each side of the cabinet with screws provided.
• Carefully lift the oven on to brackets and slide the oven into position.
Note:
• Select heat-resistant work surface material to avoid larger deformation
caused by the heat radiation from the appliance.
• This oven has forced air ventilation.
• If this appliance is to be installed near to a corner where the adjacent cabinets
run at right angles forward of the appliance, there must be a gap of at least 90
mm between the appliance and the cabinets, to prevent overheating of the
cabinets.
8
To Next Page
Loading...
