21
MICROWAVE OVEN INSTALLATION
Step 2
Open the door and fit the oven to the housing unit with the
SCREW at the INSTALLATION HOLE of TRIM KIT.
Important: Do not push the microwave fully into the housing
unit, as you still need to be able to access ADJUSTMENT SCREW
A at this stage.
Adjust the height of ADJUSTMENT SCREW A to keep a 1mm gap
between ADJUSTMENT SCREW A and the underneath of the top
surface of the housing unit.
Push the microwave fully into the housing unit
Important: do not trap or kink the power cord and make sure
that the oven is installed in the centre of the cabinet.
Step 3
Fit the TRIM-KIT PLASTIC COVER over the INSTALLATION HOLE.
To Next Page
Loading...
