Using the microwave oven
Pre-set time to start functions
Set the clock first. (Consult the instructions for setting the clock)
Input the cooking program. It’s possible to input a maximum of 2 cooking
stages. Do not use the defrost function in the pre-set function. The auto
menu can be set for a single stage only.
Example: if you want to cook with 80% microwave power for 7 minutes, to
start at a given time.
1) Press the “POWER" button once;
2) Turn the “TIMER/WEIGHT/AUTO” dial to choose 80% microwave
power till "P80" is displayed;
3) Press "START/+30SEC/CONFIRM" button to confirm;
4) Turn the “TIMER/WEIGHT/AUTO” dial to adjust the cooking time to 7
minutes;
5) After the above steps, DO NOT press " START/+30SEC/CONFIRM “
button, but do as follows :
6) Press the "CLOCK/PRE-SET“ button, the current time displays and the
hour figures flash.
7) Turn “TIMER/WEIGHT/AUTO” dial to adjust the hours, the input time
should be within 0 -23. Press " CLOCK/PRE-SET“ button and the
minute figures will flash. Turn the “TIMER/WEIGHT/AUTO” dial to
adjust the minutes, the input time should be within 0 - 59. This sets
the start time.
8) Press "START/+30SEC/CONFIRM“ to finish setting.
The ":" will illuminate, the buzzer will ring twice when the time to start
arrives, and then cooking will start automatically.
Note: The clock must be set first. Otherwise, the pre-set function will not
work.
To Next Page
Loading...
