41
Trouble Shooting
Error codes
Note: If overflow occurs, turn off the main water supply before calling a service engineer. If
there is water in the base of the tub because of an overfill or small leak, the water should
be removed before restarting the dishwasher.
Problem Causes Solution
The dishes are not
drying
Load the dishwasher as suggested in the
directions.
Increase the amount of rinse
Dishes are removed too soon
Do not empty your dishwasher immediately
after washing cycle has ended. Open the door
slightly so that the steam can escape.
Only begin unloading the dishwasher when the
dishes are cool to the touch.
Wrong program has been
selected or a program
without a drying cycle
In short programs the drying time is shorter or
the program won't have a drying cycle at all.
Choose a program with a long washing time.
The crockery is made from
non
-stick material or plastic
Remove from dishwasher and leave to dry or
dry with a dish cloth.
Use of cutlery with a low
Water drainage is more difficult with these
items. Cutlery or dishes of this type are not
suitable for washing in the dishwasher.
Error codes Meanings Possible causes
E1
Water inlet problem/fault
Water intake is restricted or water
pressure is too low
Not reaching required
temperature
The dishwasher is leaking
Software or PCB board fault
To Next Page
Loading...
Need help?
General
