For Customer Services & Spare Parts please call 0345 208 8750
Opening times: Monday - Friday 8am – 6pm & Saturday 9am – 1pm
or visit us at www.productcareuk.com
52
Trouble Shooting
Fault Possible cause Removing methods
As soon as the
appliance fills with
water, water
discharges.
• The end of the water drain hose is too
low for the machine.
• Set the water drain hose to an
appropriate height. See page
15
No water appears to
be in the drum.
• No fault. Water is in the unseen part of
the drum.
There are detergent
residues on laundry.
• Non dissolving particles of some
detergents may remain undissolved
and adhere to your laundry as white
spots.
• Perform an additional rinsing
cycle by setting your appliance
to ‘Rinsing’ programme or
clean the spots using a small
brush.
Laundry has oily like
stains on them.
• The reason for these oily like stains are
due to oil, cream or ointment that may
have been on the laundry prior to the
wash.
• Apply laundry stain remover to
affected area and repeat the
wash programme with a
maximum amount of
detergent.
Laundry remains
damp after the
drying cycle.
• The appropriated drying programme
has not been selected.
• The maximum load capacity for the
selected programme might be
exceeded.
• Select a appropriate drying
programme for the laundry.
Spinning cycle is not
performed or runs
late.
• No fault. Unbalanced load control
system has been activated.
• The unbalanced load
control system will try to
spread your laundry evenly.
• The spinning operation will
begin after your laundry is
spread. Place the laundry in
the machine in a balanced
fashion next time.
To Next Page
Loading...