6
ENG
OPERATIONAL GUIDELINES
REMOVE THE REAR COVER
Grasp the back cover with your right hand, press the release
button with your index finger, and remove the back cover.
INSTALL CO
2
CYLINDER
Hold the machine with your left hand, place the cylinder in the card
slot with your right hand, and then rotate the cylinder to the right to
screw it into the machine.
INSTALL REAR COVER
Grasp the middle part of the back cover with your right hand, align the
clip of the back cover with the machine card and gently push it toward
the machine until the back cover fits the machine.
INSTALL WATER BOTTLE
Pour water into the water bottle’s highest water line, then turn to the
right to screw the water bottle into the machine.
INFLATING OPERATION
Press down for 1 second each time. Press the gas injection button
2–3 times repeatedly. Then release the gas injection button, wait 2–3
seconds, the machine releases the residual pressure.
REMOVE THE WATER BOTTLE
After the pressure release is completed, when the bubble flows up-
ward in the water bottle, the water bottle is rotated to the left to pick
up the water bottle.
To Next Page
Loading...
Need help?
General