REPLACING THE CHAIN DRUM
Rustibus®400 machines is tted with a protective cover.
This cover oers the operator greater protection; decreases the spreading of waste and debris and
increases the eciency of the vacuum system when used on the machine.
The cover is held in place at three points (marked A – B – C) and swings open to allow access. When
replacing the chain drum or wire brush, it is only necessary to remove bolts A & B. As bolt C functions as
the hinge and therefore does not need removal.
A.
A.
B.
B.
C.
C.
Genuine Rustibus® parts only!
Machine may vary from pictures
To Next Page
Loading...