RUVATI USA
www.ruvati.com
Printed in USA
Page 3
Full hole
Half-drilled knockout holes
epiGranite
1. The sink comes pre-drilled with 1 full hole for faucet installation as well as 3 additional
half-drilled holes. If you need additional holes for either a 2- or 3- hole faucet, or for
installing soap dispenser or air switch, you can open up any of these additional holes as
well. We recommend using a 1-3/8” (35mm) diamond bit hole saw to drill through the
half-drilled holes. In that way you get a clean cut. Turn the sink upside-down and gently
drill through the hole. The half-way drilled hole makes it easy to place the drill bit and
drill securely.
Additional Faucet holes
Under-mount Installation
• Pencil
• Sink Cut-Out Template
®
®
To Next Page
