RW Flame RS-U20002 - Page 12

12
Lighting Instructions
1. Press and hold electronic
igniter button.
2. Turn the burner control to the
the
high
position; press and hold in. When
the burner lights， release the
electronic igniter button.
3. Continue to depress the burner
control knob for 30 seconds and
then release. If the flame goes
out, repeat the procedure.
4. Adjust the flame to the desired
height with the burner control
knob.
5. If the burner will not light with the
electronicigniter，hold along lit
match or long lit butane lighter to
the ignition area of the burner and
continue with step 2.
6. To shut down the burner, turn the
burner control knob clockwise to
the off position. Then turn the gas
off at the source (propane cylinder
valve or natural gas supply valve).
WARNING
FOR YOUR S AFETY:
Keep your face and body away from
burner area when lighting.
Ensure burner controls are in the
off position. Slowly turn on the
gas supply valve.
WARNING
FOR YOUR S AFETY:
The propane cylinder is equipped
wit h an excess flow device.
Unless burn er s are turned off
prior to turning the cylinder on，
only small flames and low heat
will be achievable.
WARNING
FOR YOUR SAFETY:
If the burner does not light within
10 seconds， turn the valve off and
wait for 5 minutes for any gas to
dissipate before repeating the
procedure.