2b Press the primer bulb (A) 3-5 times.
When starting a cold engine, press down the primer fully 3~5 times.
2c Start/Stop Bar Activation
Pull the stop / start bar towards the upper handle.
2c Pull cord handle
With right hand, slowly but firmly pull the starter handle and rope from the pull cord
guide until you feel resistance, then pull briskly. If the engine fails to start after three
pulls, repeat the start process. When the engine starts, return the starter rope to the
pull cord guide gently.
OPERATE OPERATE
11 12
WARNING! Too many presses on primer may cause engine flooding.
When starting a warm engine, the primer does not need to be used. If the engine stops
due to a lack of petrol, refill and press the primer 3~5 times.
NOTE! The primer is a direct prime system so the primer bubble will not the fill with fuel,
this is normal.
NOTE! Clearing a flooded engine
If the engine won’t start after you have operated the starter several times, the engine may
be flooded with excess fuel.
Use following procedure to clear and start a flooded engine.
A. Release the stop / start bar.
B. Remove the spark plug, dry it, and then reinstall it.
NOTE! Install the spark plug carefully by hand, to avoid cross-threading. After the plug is
seated,tighten 1/8 to1/4 turn with socket spanner of spark plug to compress the washer.
C. Pull the stop / start bar towards the upper handle.
D. Operate the starter as described above.
Helpline: 01904727504
Email: support@coreservice.co.uk
Website: www.coreservice.co.uk
Helpline: 01904727504
Email: support@coreservice.co.uk
Website: www.coreservice.co.uk
2c
Engine stop
Engine start
Step 3 – Mowing
Step 4 - Emptying the Grass Bag
WARNING! Always observe the strictest safety procedures when using the lawnmower.
Carefully read the safety instructions of this manual before using the lawnmower.
Start the engine and allow it run .See ”Step-2 Starting the engine”
To stop the engine, release the stop / start bar.
Keep a firm grip on the upper handle and walk, never run with the mower, be very careful
when mowing uneven or rough ground. Mow across slopes, never up and down. Be careful
when changing the direction of the mower on a slope. Do not use the mower on a steep
slope of morethan 15°.
The best result will be achieved if the grass is dry. Wet grass will tend to clog the blade
and the grass collection system. Grass grows at different rates at different time of the
year.
Never use the lowest cutting height for the first cut of the season or in drought conditions.
Only about one thirds of the grass height should be cut.
If the lawnmower will not collect the cuttings efficiently, the grass discharge chute may be
blocked. The grass bag may be full, or the underside of the mower deck may be clogged.
WARNING! Before you remove the grass collection bag, stop the engine and wait until the
blade stops completely.
WARNING! Always empty the grass bag when you have finished the mowing, even if it is
not full.
Stored grass residues are a fire hazard.
To remove the grass collection bag, raise the discharge flap with one hand and remove
the grass bag using its handle with your other hand.
To maintain safety, the discharge flap will close back to cover the rear discharge chute,
when you release the flap.
Empty the grass debris in the grass collection bag, and refit grass collection bag.
If any grass residue is caught in the discharge chute, clean it using a brush.
Do not remove grass debris in the mower casing or on the blade by hand or with your feet.
Instead use suitable tools such as a brush or broom.
To ensure that the cut grass can be collected into grass collection bag, the discharge
opening and inside the mower casing must be cleared of any blockage.
2b
A
To Next Page
Loading...