Ryobi OLM1840BL User Manual

TRANSPORTING LITHIUM BATTERIES
Transport the battery in accordance with local
and national provisions and regulations.
Follow all special requirements on packaging
and labelling when transporting batteries by a
third party. Ensure that no batteries can come
in contact with other batteries or conductive
materials while in transport by protecting
exposed connectors with insulating, non-
conductive caps or tape. Do not transport
batteries that are cracked or leaking. Check
with the forwarding company for further
advice.
MAINTENANCE
WARNING
Use only original manufacturer’s
replacement parts, accessories and
attachments. Failure to do so can cause
possible injury, can contribute to poor
performance, and may void your warranty.
WARNING
Servicing requires extreme care and
knowledge and should be performed only
E\DTXDOL¿HGVHUYLFHWHFKQLFLDQ+DYH WKH
product serviced by an authorised service
centre only. When servicing, use only
original replacement parts.
Ŷ Stop the product, remove the isolator key
and the battery pack. Make sure that all
moving parts have come to a complete stop
before any cleaning or maintenance task.
Ŷ You may make adjustments and repairs
described here. For other repairs, have the
product serviced by an authorised service
centre only.
Ŷ Replace worn or damaged part for safety.
Ŷ Check the grass catcher frequently for
wear or deterioration.
Ŷ After each use, clean the product with a
soft dry cloth. Any part that is damaged
should be properly repaired or replaced by
an authorised service centre.
Ŷ Check all nuts, bolts and screws at frequent
intervals for proper tightness to ensure the
product is in safe working condition.
Ŷ Be careful during adjustment of the product
to prevent entrapment of the fingers
between moving blades and fixed parts of
the product.
Ŷ When servicing the blades, be aware that
even though the power source is switched
off, the blades can still be moved.
Ŷ The blade on the product is sharp. Use
extreme caution and wear heavy-duty
gloves when fitting, replacing, cleaning or
checking bolt security.
Ŷ Replace damaged blades and bolts in sets
to preserve balance.
Ŷ The blade bolts must be adequately
tightened. See the manufacturer’s
recommendations for blade bolt torque
which can be found in the product
specification table in this manual.
CLEARING BLOCKAGES
Ŷ
Stop the product, remove the isolator key
and the battery pack. Make sure that all
moving parts have come to a complete
stop.
Ŷ Always wear heavy-duty gloves when
checking or clearing a blockage.
Ŷ The blades are sharp and the blockage
itself could be a sharp object.
Ŷ Remove the grass catcher, check for and
carefully clear obstructions.
Ŷ Check the grass discharge chute for
blockages and carefully clear.
Ŷ Turn the product on its side, check its
underside, and the area around the
blade. If any blockages are found, remove
carefully. Remember the blade may move
during cleaning.
RESIDUAL RISKS
Even when the product is used as prescribed,
it is still impossible to completely eliminate
certain residual risk factors. The following
hazards may arise during use, and the
operator should pay special attention to avoid
the following:
Ŷ injury caused by vibration
Ɣ Always use the right tool for the job. Use
designated handles and restrict working
time and exposure.
Ŷ injury caused by noise
Ɣ Exposure to noise can cause hearing
injury. Wear ear protection and limit
exposure.
6

Ryobi OLM1840BL Specifications

General

Brand	Ryobi
Model	OLM1840BL
Category	Lawn Mower
Language	English