Ⅶ 、 Function operation
1： Cumulation
Weight cumulation：Put the object on the scale when it is
showing zero and stable. Press and wait it to show
“Add xx”within 2 seconds，if you want to keep weighing，you
have to take the object off and wait it shows zero，then put the
object on the scale and wait it stable，then press if you
want to weigh more.
2：Cumulative indications
In the state of weighing, long press for 3s，the single
window display the accumulated number of bills, press
to to return to the weighing state. Press to delete dates.
3：Upper and lower limit setting
Lower limit value setting: press longer than 3s,
enter the setting，it shows“dn”and“0.0”，then press to
change and to move，then input lower limit value，
press to confirm.
Upper limit value setting: longer press 3s in the state of
weighing and into upper value setting，it shows“UP”and“0.0”
and flash，press and to move，then input upper
value，press to confirm.
Setting the value rapidly: press or over 3s when
put object on, take the weight of the object as the upper or
lower limit.
1>If the lower limit is 0 and the upper limit is not 0, it
represents: when the weighing data is greater than the upper
limit value, an alarm is issued.
2>If only the lower limit value is not 0, the upper limit value is
0, which means: When the weighing data is less than the lower
limit value, it will alarm
3>If only the lower limit value is not 0, the upper limit value is
not 0, and the lower limit value is less than the upper limit
value, which means: when the weighing data is less than the
lower limit value, or greater than the upper limit value, the
alarm is issued.
To Next Page
Loading...
Need help?
General