To Next PageTo Next Page
Need help?Do you have a question about the S.R.Smith AS-100P and is the answer not in the manual?
Instructions for correctly positioning the anchor on the deck during new concrete pours.
Detailed steps for retrofitting the anchor into existing concrete structures.
Determine anchor location, drill a minimum 13cm/5in diameter hole at least 18cm/6.5in deep.
Remove base/fill material if concrete thickness is less than required hole depth.
Electrically bond the anchor by attaching a wire from the bonding grid to the anchor body.
Fill area around anchor with cement/epoxy, ensure flush surface, and check for levelness.
General