221Car care
Changing filter, 4-cyl engine
1 Unscrew the oil filter cap.
• Lift the cap slightly and carefully pry
apart the cap and the filter housing.
• Remove the filter cap.
2 Remove the filter. Have paper towelling
or a rag at hand to catch the oil that
escapes from the filter.
3 Fit a new filter.
4 Fit a new O-ring in the cap. Apply a small
amount of new engine oil to the O-ring.
5 Screw on the cap. The correct tightening
torque is 25 Nm (18 lbf. ft).
Changing filter, V6 engine
1 Unscrew the oil filter cap. Have paper
towelling or a rag at hand to catch the oil
that escapes from the filter.
2 Remove the cap and the filter.
3 Change the O-ring in the cap. Lubricate
this with a small amount of new engine
oil.
4 Fit a new filter.
5 Screw on the cap. The correct tightening
torque is 25 Nm (18 lbf ft).
Oil filter, 4-cyl engineDrain plug, 4-cyl engine
Drain plug, V6 engine Oil filter, V6 engine
93U SM 06.book Page 221 Friday, February 18, 2005 1:15 PM
To Next Page
Loading...
