2 53 29 271
Saab 9-5 B205, B235
1 Read fully through the installation instructions
and check that all the parts are present in the kit.
2 Lay covers on the wings and remove the cap on
the coolant system expansions tank.
3 Raise the car. Use a receptacle to collect the
coolant. Remove the air shield behind the
bumper, connect a hose, open the drain plug
and drain the coolant.
4 Lower the car to a suitable working height for fit-
ting the connector plug to the bumper shell.
WARNING
Take care if the engine is hot. The coolant will also
be hot. You could get burnt if you brush against the
exhaust manifold.
E930A260
2
3
To Next Page
Loading...