Unpacking the washing machine
Warning!
• Packaging material (e.g. Films, Styrofoam) can
be dangerous for children.
• There is a risk of suocation! Keep all
packaging well away from children.
1. Remove the cardboard box and Styrofoam packing.
2. Lift the washing machine and remove the base packing. Make
sure the small triangle foam is removed with the bottom one
together. If not, lay the unit down with side surface, then remove
the small foam from the unit bottom manually.
3. Remove the tape securing the power supply cord and drain hose.
4. Remove the inlet hose from the drum.
Remove transport bolts
Warning!
• You must remove the transport bolts from the backside before
using the product.
• You’ll need the transport bolts again if you move the product,
so make sure you keep them in a safe place.
Please take the following steps to remove the
bolts:
1. Loosen 4 bolts with spanner and then remove
them.
2. Stop the holes with transport hole plugs.
3. Keep the transport bolts properly for future use.
61
GB
To Next Page
Loading...
Need help?
General
