draining due to objects such as safety pins, coins etc. blocking the
pump.
The Service panel proceed as follows:
1. After the power
is dis connected,
use hand to open
the lter cover.
2. Turn the lter
down as shown
with the gure and
take out sundries
matters.
3. Reinstall each part
back after sundries
matters are
removed.
Warning!
When the appliance is in use and depending on the programme
selected there can be hot water in the pump. Never remove the
pump cover during a wash cycle, always wait until the appliance
has nished the cycle, and is empty. When replacing the cover,
ensure it is securely retight end so.
3. Reconnect the inlet pipe.
4. Open the tap and make sure there is no water leakage.
5. Close the tap.
Notes: Generally, the tap lter is washed rst and then the lter
in washing machine will be washed. If only the lter in washing
machine is washed, then the steps 1 ~3 in cleaning the tap lter
shall be repeated.
Pull out the power plug to avoid electrical shock before washing.
After using the washing machine, pull out the power cord and
close the door tightly to avoid pinching the kids.
Remove foreign matters
Drain Pump Filter:
Drain pump lter can lter the yarns and small foreign matters
from the washings.
Clean the lter periodically to ensure the normal operation of
washing machine.
According to the soil level within the cycles and the frequency of
the cycles, you have to inspect and clean the lter regularly.
The pump should be inspected if the machine does not empty
and/or spin; The machine makes an unusual noise during
8988
To Next Page
Loading...
Need help?
General
