To Replace the Batteries:
• Unscrew and slide off the cover at the front of the main unit.
• Remove the old batteries and replace with 4 x new 1.5V
LR44 alkaline batteries noting the polarity diagram inside
the compartment.
• Replace the battery cover and tighten screw.
WARNING:
• Immediately dispose of used batteries and keep away from
children. Do NOT dispose of batteries in household trash.
• Even used batteries may cause severe injury or death.
• Call a local poison control center for treatment information.
• Do not mix old and new batteries, different
brands or types of batteries, such as alkaline, carbon-zinc,
or rechargeable batteries.
• Ensure the batteries are installed correctly according to
polarity (+ and -).
• Remove and immediately discard batteries
from equipment not used for an extended period of time.
• Do not force discharge, recharge, disassemble, expose to
high temperatures or incinerate. Doing so may result in
injury due to venting, leakage or explosion resulting in
chemical burns.
3. Installing the Unit
• Clean the surfaces you want to mount the alarm on using
cleaning alcohol or similar. Ensure the surfaces are
completely clean and dry before proceeding.
• Using the double-sided adhesive pad provided, mount the
alarm and magnetic sensor on the door or window to be
protected, placing one of the units on the part of the fixture
which opens and the other on the stationary part of the
fixture (frame).
• Ensure that when the door or window is closed the arrows
on two parts of the alarm are aligned with less than 15mm
between them.
4. Operation
To Arm the Unit in ALARM Mode
• Toggle the switch to the position.
When the door or window is opened (causing the sensors
to separate by more than 15mm) the alarm will sound
continuously until the door or window is shut, or the unit is
disarmed.
Kit Includes:
1 x Magnetic Window/Door Alarm
1 x Double Sided Mounting Tap Set
1 x Instruction Leaflet
1. Introduction
The Magnetic Window/ Door Alarm is designed to sound an
intruder alarm or visitor chime when a door or window is
opened. The simply switch in the battery compartment of the
unit can toggle between the different modes or switch the unit
off when it is not required.
2. Battery Installation
The Magnetic Window/ Door Alarm requires
4 x 1.5V LR44 alkaline batteries (included).
WARNING: Contains coin battery.
INGESTION HAZARD keep away
from children.
To Activate the Batteries:
• Unscrew and slide off the cover at the front of the main
unit.
• Carefully remove the clear plastic insulation tab from the
batteries. If the batteries are dislodged, replace them
noting the polarity diagram inside the battery compartment.
• Replace the battery cover and tighten screw.
It is recommended that the alarm power is regularly tested by
pressing the test button in the battery compartment. If
the light illuminates, the batteries are in good condition. If it
fails to illuminate, replace all of the batteries.
To Operate the Unit in CHIME Mode
• Toggle the switch to the position.
When the door or window is opened (causing the sensors
to separate by more than 15mm) the chime will sound.
To DISARM the Unit
• Toggle the switch to the position.
When the door or window is opened (causing the sensors
to separate by more than 15mm) the unit will make no
sound.
5. Care & Maintenance
To clean the unit housing, use a soft cloth dry.
Do not use chemical agents as this damage and discolor the
unit.
FCC COMPLIANCE STATEMENT
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may
cause undesired operation.
WARNING: Changes or modifications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
WARNING
Limitations of Alarm Products
Test product regularly to ensure it functions in accordance with
these instructions. Security Equipment Corporation (SEC) is not
providing insurance or any guarantee that the risk of burglary
or robbery will be reduced or prevented even if this product is
used properly. SEC recommends that users obtain proper
insurance coverage for these risks. SEC does not represent or
warrant that this product may not be compromised or
circumvented, that it will provide proper or adequate warning,
or that the use of this product will prevent injury, property
damage or other losses. Note that this product may be
bypassed, compromised, fail or fail to warn like any alarm,
including due to improper installation, positioning, or
maintenance, tampering; dead, faulty, or improperly installed
batteries; sensing limitations and component failures. The
product’s functional range may be affected or limited by
environmental conditions, radio frequency interference or other
obstructions. Audible alarm signals may be outside of hearing
range, muted by doors, walls, and floors, unheard by deep
sleepers or the hearing-impaired, or overwhelmed by other
sounds.
90 DAY LIMITED WARRANTY
Security Equipment Corporation warrants this product to be
free from manufacturing defects for a period of ninety days
from the original date of consumer purchase. This warranty is
limited to the repair or replacement of this product only and
does not extend to consequential or incidental damage to other
products that may be used with this unit. This warranty does
not cover products which have been abused, altered or
damaged. This warranty is in lieu of all other warranties
express or implied. TO THE EXTENT PERMITTED BY LAW, SEC
DISCLAIMS ALL OTHER IMPLIED OR EXPRESS WARRANTIES,
INCLUDING THE WARRANTY OF MERCHANTABILITY AND/OR
FITNESS FOR A PARTICULAR PURPOSE.
LIMITATIONS OF LIABILITY: This limited warranty is your
sole remedy and SEC shall not be liable for any damages,
whether direct, indirect, incidental, special, consequential,
exemplary or otherwise, including lost revenue and lost profits,
arising out of any theory of recovery, including statutory,
contract or tort. In no event will SEC’s entire liability exceed the
purchase price of this product. Some states and provinces do
not allow the exclusion or limitations on how long an implied
warranty lasts or permit the exclusion or limitations of
incidental or consequential damages, so the above limitations
or exclusions may not apply to you. This limited warranty gives
you specific legal rights, and you may also have other rights
which vary from state to state and province to province.
If unit should prove defective within the warranty period, return
prepaid with dated proof of purchase to:
Security Equipment Corporation
747 Sun Park Drive
Fenton, MO 63026
Please keep these instructions in a safe place for future
reference.
Model HS-RL-DWA2
DOOR OR WINDOW ALARM
INSTALLATION AND OPERATING INSTRUCTIONS
To Next Page
Need help?
General
