EasyManua.ls Logo

Saeco MAGIC COMFORT+ - Brewing Coffee; Using Pre-ground Coffee; Hot Water Dispensing; Steam for Milk and Drinks

Saeco MAGIC COMFORT+
26 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
20
BREWING
Place one or two preheated cups on the grill (3) under
the dispenser (6). Press the relevant selection key. The
machine will automatically dispense the selected
coffee.
The coffee flow may be stopped at any moment by
pressing any selection button (except the standby
switch), for instance when an excessive quantity of
water has been selected. Should you interrupt the
coffee flow after the first of two coffees has been
brewed, the second is not dispensed.
Pre-ground coffee
Make sure to use pre-ground coffee only (medium
ground). Never use whole beans or soluble coffee!
Right before making coffee, fill the container with
freshly ground coffee. Remember that ground coffee
ages soon, thus losing its quality.
30
Use the measuring spoon supplied to fill the container
(14) with ground coffee. Use a full measure only.
Then, press the pre-ground coffee selection button
and the desired selection key (regular, espresso
or tall coffee) to obtain a cup of coffee. It is not
possible to obtain a second cup of coffee.
The coffee flow may be stopped at any moment by
pressing any selection button (except the standby
switch), for instance when an excessive quantity of
water has been selected.
Hot water
Hot water dispensing is accomplished through an
independent water circuit which ensures the correct
temperature and supplies tasteless hot water to be
used for tea, soup, etc.
Press the hot water key, the display will show:
"HOT WATER "
During hot water dispensing, only the programmed
amount is dispensed if the corresponding program-
ming is enabled. On the contrary, dispensing should
be stopped by pressing again the selection key when
the desired amount is reached.
To program the hot water amount, it is necessary to
keep the corresponding selection key pressed till the
desired amount is reached.
Attention: hot water can only be pro-
grammed if the corresponding program-
ming function is enabled (see page 37).
During the programming phase, the following mes-
sage will be displayed:
"HOT WATER "
"PROGR. QUANTITY "
31
Place a glass or cup under the steam/hot water spout
(7), then press the hot water selection key. Hot water
will be automatically dispensed.
Steam
To heat milk or other drinks.
Always clean the spout with a damp cloth soon after
the use; otherwise, it might be difficult to remove milk
residues.
Turn the steam knob (9), the display will show:
"STEAM "
Direct steam/hot water spout (7) on cup holder grill
(3) and slightly open knob (9), turning it
counterclockwise.
Wait until the remaining water has flown out of the
spout. Then, move the spout outwards and plunge it
deeply into the fluid to be heated.
32
Slowly open the steam/hot water knob and heat the

Other manuals for Saeco MAGIC COMFORT+

Related product manuals