Need help?Do you have a question about the SAF Phoenix G2 IDU and is the answer not in the manual?
General| Brand | SAF |
|---|---|
| Model | Phoenix G2 IDU |
| Category | Network Hardware |
| Language | English |
Summary of the main features and capabilities of the Phoenix G2 IDU.
Explanation of the information found on device labels, including model and serial numbers.
Description of physical interfaces and status indicators on the IDU front panel.
Illustrations of typical deployment scenarios and configurations of the Phoenix G2 system.
Introduction to the EMM extension modules and their purpose.
Details on the ASI EMM extension module's interfaces and capabilities.
Detailed information and connection examples for the E1/T1 EMM module.
Overview of interfaces and ports for Phoenix G2 ODUs and IRFUs.
Description of the Standard Power (SP) and High Power (HP) ODU interfaces.
Details on the SP/HP ODU when equipped with a SAF2 adaptation interface.
Description of the Very High Power (VHP) ODU interfaces.
Description of the IRFU unit featuring an integrated diplexer.
Description of the IRFU unit without an integrated diplexer.
Description of the Indoor Branching Unit (IBU) without an active switch.
Description of the Indoor Branching Unit (IBU) with a built-in active switch.
Initial steps for installing the Phoenix G2 IDU in a rack.
Procedure for installing a single IDU unit in a rack.
Procedure for installing two interconnected IDU units in a rack.
Instructions on how to attach the Phoenix G2 ODU to an antenna.
Specific instructions for attaching the SP/HP ODU to an antenna.
Connecting VHP and SP/HP ODUs with SAF2 adaptation interfaces.
Specifications for cables used in the system, such as IDU-ODU cables.
Steps for providing power to the Phoenix G2 IDU and ODU units.
Steps for initial setup and system requirements for accessing the Web GUI.
Specifies the PC requirements for accessing the Phoenix G2 IDU Web GUI.
Adjusting IPv4 settings for the LAN adapter for Web GUI access.
Steps for accessing the Web GUI using the MNG USB B serial port.
Instructions on how to connect to and access the device's Web GUI via Ethernet.
Overview of the Web GUI structure, including login and main sections.
Explanation of the Web GUI's header and status bar elements.
Details on navigating the menu structure and managing user sessions.
Description of various buttons and their functions within the Web GUI.
Guide for configuring fundamental system parameters like design type and modes.
Selecting and configuring the system's design type and functional modes.
Steps for configuring the device's IP addresses, subnet masks, and gateway.
Settings for modem and radio parameters, including bandwidth and frequency.
Options for configuring remote management access via in-band or out-band methods.
Overview of the system's operational status and monitoring.
Display of the overall system status and key parameters.
Details on modem, RF/IF unit status, and running IP configuration.
Information about the current license status and available features.
List of currently active alarms and events.
Display of modem performance counters and error rate statistics.
Display of selected values over time, showing current trends.
Device hardware/software information and radio part details.
Section for configuring system and link parameters.
Selection of Design Type, Duplex Mode, and Functional Mode for the system.
To Next Page
