Sage Oracle Jet SES985 - Assembly; Before First Use; Machine Preparation; Installing the Water Filter

9
EN
BEFORE FIRST USE
Machine Preparation
Remove and discard all labels and packaging
materials attached to your espresso machine.
Ensure you have removed all parts and
accessories from the box before discarding the
packaging.
Remove the water tank located at the back of the
machine unlocking the latch and pulling the water
tank from the latch handle.
Clean parts and accessories (water tank,
portalter, lter baskets, milk jug) using warm water
and a gentle dish washing liquid. Rinse well then
dry thoroughly.
NOTE
Machines with colour, drip tray protection guard is
included. DO NOT DISCARD.
INSTALLING THE WATER FILTER
• Remove the water lter and water lter holder
from the plastic bag.
• Soak the lter in cold water for 5 minutes.
• Rinse the lter holder with cold water.
• Set a reminder for replacement. We
recommend to replace lter every 3 months.
• Insert the lter into the two parts of the lter holder.
• To install the assembled lter holder into the water
tank, align the base of the lter holder with the
adapter inside the water tank. Push down to lock
into place.
NOTE
Replacing the water lter every three months will
reduce the need to descale the machine. Filters can
be purchased at www.breville.com
NOTE
Input the water hardness test strip result to the
machine. If result is 4 or 5 bars when tested, we
strongly recommend to change to an alternate water
source. Filtered water will extend both the life of your
built-in lter and descale intervals as well as provide
superior taste. Ensure to test the water hardness of
the alternative water source you've chosen and input
into the machine accordingly. Avoid using overly
ltered water, like RO water unless some mineral
content is being added back to the nal water. Never
use distilled water, or water with no or low mineral
content as this will aect the taste of coee.
Assembly