2 - OPERATION
Installation and User Guide - N56717020101
Page A2-14
No reproduction or communication without the written consent of
SAGEM SA
Alarms Description Severity
LPT :
Lower order Path Termination
SD-V5 (VC12) Signal Degrade –V5 minor
SD-B3 (VC3) Signal Degrade –B3 minor
LO-SLM Low order Path – Signal Label Mismatch Non-alarmed
LO-RDI Low order Path – Remote Defect Indication minor
LO-UNEQ Low order Path – Unequipped Non-alarmed
LPA :
Lower order Path Adaptation
LO-SLM Low order Path – Signal Label Mismatch Non-alarmed
PPI :
PDH Physical Interface
LOS Loss Of Signal minor
AIS Alarm Indication Signal Non-alarmed
SETS :
Synchronous Equipment Timing Source
T3 LOS Loss Of Signal on T3 sync input minor
T1 LOS Loss Of Signal on T1 sync input Non-alarmed
T2 LOS Loss Of Signal on T2 sync input Non-alarmed
T4 - Failure Failure on T4 synchronization output minor
Local equipment
Local user
inputs # 1
Remote indication 1 Non-alarmed
Local user
inputs # 2
Remote indication 2 Non-alarmed
Local user
inputs # 3
Remote indication 3 major
Local user
inputs # 4
Remote indication 4 minor
Remote equipment
Far user inputs
# 1
Remote indication 1 Major *
Far user inputs
# 2
Remote indication 2 Minor *
Others
Message Card configuration major
Message Defective card major
Message Missing card major
Table 2-10 : Alarms and severity (2/2)
* If the equipment configured is declared centre site.
To Next Page
Loading...