Safe Usage and Certications:
1. Place the product on a flat surface.
2. Connect the manufacturer supplied AC power adapter. The Optimum Stream requires the
use of a 12 VDC, 1A power adapter in compliance with PS2 or LPS according to annex Q of UL
62368-1. Only use a manufacturer supplied and approved power adapter. Always rst plug the
adapter lead into the Optimum Stream, then the AC adapter into the AC wall socket. If you do
not follow this sequence for set-up, you may get an electric shock.
3. Connect the power adapter to the AC outlet in accordance with the markings on the
identication label (voltage, current, and frequency of electricity network).
4. Optionally, connect the Ethernet cable to the RJ45/Ethernet ports. Then connect the other
end of the Ethernet Cable to the Ethernet port of your internet service device..
When using this device, basic safety precautions should always be followed to reduce the risk of
re, electric shock, and injury to persons including the following:
1. Do not use this product near water and avoid contact with moisture. For example, do not use
it near a bathtub, wash bowl, kitchen sink, laundry tub, in a wet basement, or near a swimming
pool. Care should be taken so that liquids are not spilled on this equipment.
2. This equipment is for indoor use only, do not place or install it in an outdoor location.
3. Do not overload wall outlets or extension cords. Doing so can result in the risk of re or
electrical shock.
4. The equipment should be situated away from heat sources such as radiators, heat registers,
stoves, or other heat-producing appliances and equipment.
5. Care should be taken to ensure that the power cord is routed so it is not likely to be walked on
or pinched by items placed upon or next to it.
6. Unplug this equipment before cleaning. Do not use liquid cleaners or aerosol cleaners.
Use a damp cloth for cleaning only.
7. This equipment is not user serviceable and is to be serviced by qualied personnel only.
Do not disassemble this equipment. If service is required, disconnect all power from the
equipment and consult qualied service personnel.
8. To disconnect this equipment from AC power, unplug the power supply from the AC
wall socket.
9. Make sure the power socket to which you connect the power cord is easily accessible and as
close as possible to the equipment so that the appliance can be unplugged quickly in case of
a problem.
Radio Frequency Interference Statement
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
FCC Radio Frequency Radiation Exposure Statement
This equipment complies with “FCC1.1310 for radio frequency radiation exposure limits set forth
for an uncontrolled environment”.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
This device produces radio frequency energy in the 2.4 GHz and 5 GHz spectrum. The antenna
should be positioned to keep a minimum distance of 30cm (0.98ft) from the radiating element to
any nearby person.
Federal Communications Commission (FCC) Statements
FCC ID: VW3DIW377
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Modications:
You are cautioned that changes or modications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
FCC Responsible Party: Sagemcom USA
14651 N. Dallas Parkway
Suite 900
Dallas, TX 75254
Phone: 972-674-4100
Model Name: DIW377 ALT US
Product Name: Optimum Stream
Licenses and trademarks
The terms HDMI, HDMI High-Denition Multimedia Interface, and the HDMI logo are trademarks
or registered trademarks of HDMI Licensing Administrator, Inc.
Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio, Dolby Vision and the
double-D symbol are trademarks of Dolby Laboratories Licensing Corporation.
Wi-Fi
®
and Wi-Fi logo are registered trademark of Wi-Fi Alliance.
Bluetooth
®
is a registered trademark of Bluetooth SIG, Inc.
Google is a trademark of Google LLC.
CS-14154_Stream_Insert_105mmx148.5mm.indd 3-4CS-14154_Stream_Insert_105mmx148.5mm.indd 3-4 6/24/22 8:49 AM6/24/22 8:49 AM
To Previous Page
Loading...
Need help?
General