2 – Control Module Design
Connection for limit switches and Z-Probe
Limit switches as well as a measuring device for the Z-axis (Z-probe) can be connected via the 16-pin plug that is also
available at the bottom edge of the control module.
Pin assignment: +5V A5 Z-lim Z-lim Y-lim Y-lim X-lim X-lim
GND GND GND GND GND GND GND GND
PCB edge
Hint:
Please note that the labeling for the connections of the X- and Z-limit switches on the board is reversed.
To Next Page
Loading...