“Set Lower” Button
Used to set temperature in lower zone.
VSC3207 VAC0732
RUN
Indicator light illuminates to signify the cooling mode is currently in operation.
“UP” Button
Used to raise(warm) the temperature in 1℃.
“DOWN” Button
Used to lower(cool) the temperature in 1℃.
Setting the Temperature Control
VSC4507
The Wine cooler has two temperature zones.
Upper zone – temperature range 5℃ to 10℃
Lower zone – temperature range 10℃ to 18℃
You can set the required temperature either zone by pushing the Set Upper or Set Lower
button. When you push the two buttons for the first time, the LED readout will show the
previously set temperature set for that zones .
The temperature preset at the factory are:
Upper zone:: 6℃
Lower zone: 12℃
To set the temperature in the Upper zone press Set Upper button once. The present
temperature will flash. The temperature will decrease by every time the button is pressed
until minimum temperature is reached, at which point it will then revert back to its maximum
setting and start again.
To set the temperature in the Lower zone press the Set Lower button and follow the
instructions above.
To view the temperature set in either zone at any time, press the corresponding “Set
Upper” or “Set Lower” button, the “Set” temperature will temporarily flash in the LED
display for 5 seconds.
VSC3207 VAC0732
The Wine cooler has one temperature zone.
Temperature range 5℃ to 18℃.
You can set the temperature as you desire by pushing the UP or DOWN button. When you
push the two buttons for the first time, the LED readout will show the original temperature
set at previous time .
The temperature preset at the factory is 12℃ (54ºF)
The temperature that you desire to set will increase 1ºC if you push the UP button once, on
the contrary the temperature will decrease 1ºC if you push the DOWN button once.
To Next Page
Loading...