SAJ eSolar RS485 - MeterS-485 Power On and Status Check

- 8 -
Figure 2-5
⑥Power On
Power on the eSolar MeterS-485 and it will start operation. (If meter failed to
communicate with module, it will display “off line” in the meter screen
；
if
succeeded, “on line” will be displayed.)
Note:
1.There are 11 terminals on the eSolar MeterS-485 in total while actually only 6
will be used, as shown in Figure 2-4.
2.eSolar MeterS-485 and CT are not waterproof or dust-proof, it is recommended
to install inside a distribution box.
L
N
PE
P1