Need help?Do you have a question about the Salda RIRS 400 V EKO 3.0 Series and is the answer not in the manual?
General| Model | RIRS 400 V EKO 3.0 |
|---|---|
| Category | Industrial Equipment |
| Voltage | 400 V |
| Series | 3.0 |
| Frequency | 50 Hz |
| Ecodesign compliance | Yes |
| Airflow | 400 m3/h |
Check installation, connections, and readiness of all devices before initial operation.
Lists common failures, their causes, and corrective actions for the unit.
Instructions for fan inspection, cleaning, and repair by trained personnel.
Procedures for cleaning and maintaining the heat exchanger for efficient operation.
Information on electrical heater servicing and thermal protection mechanisms.
Details on various protection steps for water and electric heaters against freezing and overheating.
Explains connecting the unit to a Building Management System via ModBus protocol.
Lists ModBus addresses for various parameters and their data types.
Guidelines for safe and compliant electrical connections by qualified electricians.
Instructions for adjusting system parameters and settings using the control panel.
Details the labeling and characteristics of the control board and connected components.
Outlines periodic visual inspections for the switching device and blade switch.
Wiring diagram for connecting the RIRS 400 VE EKO 3.0 model.
Wiring diagram for connecting the RIRS 400 VW EKO 3.0 model.
Wiring diagram for connecting the RIRS 700 VE EKO 3.0 model.
Wiring diagram for connecting the RIRS 700 VW EKO 3.0 model.
Provides warranty terms, conditions, and coupon details for the product.
To Next Page
