Sam4s ER-180T Series - Program 350 - PLU Link Programming

62  Program Mode Programming SAM4s ER-180T Operator's & Programming Manual v1.4
Program 350 - PLU Link Programming
When a PLU is registered, the amount of the PLU is “linked” or reported to a department.
The sale amount of the PLU will be reported in for the appropriate PLU in the PLU report
and also in the department it is linked to.
Note: If a PLU is not linked to a Department, it’s sales will by default link to
Department #1.
1. Turn the control lock to the P position.
2. To begin the program, enter 3 5 0, press the SUBTOTAL key.
0 SUBTOTAL5 3
3. Enter the PLU number (1-500) and press the PLU key.
PLU
Enter the PLU#,
(1-500)
4. Press the Department key on the keyboard where you wish the PLU sales
reported.
12
5. To program additional PLUs, repeat from step 3, or press the CASH/TEND
key to finalize the program.
CASH/TEND
(
=
)