Sam4s ER-180T Series - System Option Programming

SAM4s ER-180T Operator's & Programming Manual v1.4 Program Mode Programming  63
System Option Programming
Read each option carefully to determine if you wish to make any changes.
NOTE: Because after clearing memory all options settings are automatically set to 0,
and because your most likely option selections require a status setting of 0, you do not
need to program this section unless you wish to change the default status.
Programming a System Option
1. Turn the control lock to the P position.
2. Enter 3 0, press the SUBTOTAL key.
3. Enter a system option address, and then press the X/TIME key.
4. Enter the number representing the status you have selected. Press the
SUBTOTAL key.
5. Repeat from step 3 for each system option you wish to change.
6. Press the CASH/TEND key to end system option programming.
System Option Flowchart
SUBTOTAL X/TIME
Status
CASH/TEND
(
=
)
Repeat for each
S
y
stem Option
Option #
SUBTOTAL
0 3