Sam4s ER-180T Series - Print Option Programming

SAM4s ER-180T Operator's & Programming Manual v1.4 Program Mode Programming  65
Print Option Programming
Read each option carefully to determine if you wish to make any changes.
NOTE: Because after clearing memory all options settings are automatically set to 0,
and because your most likely option selections require a status setting of 0, you do not
need to program this section unless you wish to change the default status.
Programming a Print Option:
1. Turn the control lock to the P position.
2. Enter 4 0, press the SBTL key.
3. Enter a print option address, and then press the X/TIME key.
4. Enter the number representing the status you have selected, or if there is more
than one decision to be made in an address, add the values representing your
choices for each decision and enter the sum. Press the SUBTOTAL key.
5. Repeat from step 3 for each print option you wish to change.
6. Press the CASH/TEND key to end print option programming.
Print Option Flowchart
SUBTOTAL X/TIME
Status
CASH
Repeat for each
Print Option
Option #
SBTL 0 4
NOTE 1: Print Option# 3 – Users outside of the USA can designate a different currency
symbol. To select a different symbol enter three digit alpha character codes.
NOTE 2: Print Option# 4 – If you are using the currency conversion feature, you can
select the appropriate symbol for each foreign currency you are accepting. To select a
different symbol enter three digit alpha character codes.