Sam4s ER-180T Series - Program 80 - Function Key Descriptor; Program 90 - Function Key HALO

SAM4s ER-180T Operator's & Programming Manual v1.4 Program Mode Programming  69
Program 80 - Function Key Descriptor
1. Turn the control lock to the P position.
2. To begin the program, enter 8 0, press the SUBTOTAL key.
0 SUBTOTAL8
3. Enter up to 8 three-character codes and press the FUNCTION KEY. Refer to
the descriptor code chart on 57.
Enter up to 8
three-character
codes
FUNCTION
KEY
4. To program additional function keys, repeat from step 3, or press the
CASH/TEND key to finalize the program.
CASH/TEND
(
=
)
Program 90 - Function Key HALO
Use Program 90 to program a high amount lock out (HALO) for a function key. Only specific
keys require this program. For example, you can set a HALO for the CASH/TEND, CHECK
or CHARGE keys. Refer to the specific function key programming information in this
chapter to determine when the HALO option is available.
1. Turn the control lock to the P position.
2. To begin the program, enter 9 0, press the SUBTOTAL key.
0 SUBTOTAL9
3. Enter a HALO of up to eight digits, (or "0" for no HALO).
Enter 1-8 digit
HALO
4. Press the function key on the keyboard you wish to program.
FUNCTION
KE
Y
5. To program additional function keys, repeat from step 2, or press the
CASH/TEND key to finalize the program.
CASH/TEND
(
=
)