•
••
• 42 User Messages
Error Reset
If the register is in an error which cannot be cleared the following operation
will reset the current transaction and clear the error without any loss of
pre-programmed data.
• Power OFF, press the key and while still
pressing the key, power ON
• The register prints INITIAL CLEAR OK !
• Move to the REG position.
• At the CLOSED prompt enter and press
CLOSED
A Clerk must be signed on in order to operate the Register.
- Enter Clerk Number 1 to 10 and press the CLERK key. I.e. 1 CLERK
1
To Next Page
Loading...
